3D Innovations NC60 User Manual download pdf (Page 177)

Control Panel Messages

Chapter 5: Troubleshooting

❖

5-9

U1-RAM ERROR

POWER OFF/ON

There is a print engine RAM fault. Power the printer off and on. If the fault

persists, call for service.

U2-NVRAM ERROR

POWER OFF/ON

There is a print engine NVRAM fault. Power the printer off and on. If the fault

persists, call for service.

U3-COMM.FAULT

POWER OFF/ON

There is a controller/engine communication fault. Power the printer off and on.

If the fault persists, call for service.

U4-OPTICS FAULT

POWER OFF/ON

There is a laser system fault. Power the printer off and on. If the fault persists,

call for service.

U5-POLYGON FAULT

POWER OFF/ON

There is a polygon motor fault. Power the printer off and on. If the fault

persists, call for service.

U6-MOTOR FAULT

POWER OFF/ON

There is a developer motor fault. Power the printer off and on. If the fault

persists, call for service.

U7-MOTOR FAULT

POWER OFF/ON

There is a main motor fault. Power the printer off and on. If the fault persists,

call for service.

W1-COLOR DEV MOD

NEAR END OF USE

W1 - Color developer cartridge near end of use. Order a new color developer

cartridge.

W2-BLACK DEV MOD

NEAR END OF USE

W2 - Black developer cartridge near end of use. Order a new black developer

cartridge.

W3-PRINT DRUM

NEAR END OF USE

W3 - Print drum near end of use. Order a new print drum.

W4-FUSER MODULE

NEAR END OF USE

W4 - Fuser module near end of use. Order a new fuser module.

W5-FUSER OIL/PAD

NEAR END OF USE

W5 - Fuser oil and pad near end of use. Replace oil bottle.

WAIT:ADJUSTING

PRINT QUALITY

Please wait - Adjusting print quality

WAITING

job filename

Printer waiting for data.

Table 5.1 Control Panel Messages and Corrective Actions

Message Explanation/Required Action

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 185 186

Comments to this Manuals

No comments

3D Innovations NC60 User Manual Page 177

Comments to this Manuals