3D Innovations NC60 User Manual download pdf (Page 145)

Adjusting Density and Color Balance

Chapter 4: Maintaining the Printer

❖

4-11

What To Look For

There are basically three things to look for in examining

the test print.

1. The Color Density and the Black Density are a matter

of taste. The 30% halftones can be used to judge the

current level and decide on a preference.

2. The Color Density and Black Density should be at

approximately the same level. This is important in

order to make the Color Balance adjustment.

3. The correct Color Balance is determined by

comparing the circle in the center of the Color

Balance object marked “CURRENT” with the gray

background. The background is produced using black

only and the circles are produced using a combination

of cyan, magenta, and yellow. The adjustment

objective is for the “CURRENT” circle to be the closest

gray of any of the circles when compared to the

background.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 185 186

No comments

3D Innovations NC60 User Manual Page 145